Cartman02au at 01:25, 11 January 2010

2010-01-11T01:25:23Z

← Older revision		Revision as of 01:25, 11 January 2010
Line 2:		Line 2:
	[[Image:Km1776_side.jpg\|right\|thumb\|200px\|A KM177-6 from the front side]]		[[Image:Km1776_side.jpg\|right\|thumb\|200px\|A KM177-6 from the front side]]
	[[Image:Km1776_torque.jpg\|right\|thumb\|200px\|A KM177-6 torque convertor]]		[[Image:Km1776_torque.jpg\|right\|thumb\|200px\|A KM177-6 torque convertor]]
	The '''KM177-6''' (also known as F4A23)is a four-speed electronic automatic transaxle built by Mitsubishi and was used in all [[TP]] models and carburettored [[:Category:Second Generation\|Second Generation]] models.		The '''KM177-6''' (also known as F4A23)is a four-speed electronic automatic transaxle built by Mitsubishi and was used in all [[TP]] models and carburettored [[:Category:Second Generation Magna/Verada\|Second Generation]] models.

	After discovering that the [[KM175]] was failing often in service, [[MMAL]] decided that both carby and fuel-injected TP Magnas would be fitted with the stronger transaxle.		After discovering that the [[KM175]] was failing often in service, [[MMAL]] decided that both carby and fuel-injected TP Magnas would be fitted with the stronger transaxle.
Line 47:		Line 47:
	\|}		\|}

	[[Category: First Generation]]		[[Category: First Generation Magna]]
	[[Category: Automatic Transaxles]]		[[Category: Automatic Transaxles]]

Administrator: Protected "KM177-6" [edit=sysop:move=sysop]

2008-01-18T11:17:11Z

Protected "KM177-6" [edit=sysop:move=sysop]

New page

[[Image:Km1776_front.jpg|right|thumb|200px|A KM177-6 from the engine side, shows differential housing and torque convertor]]
[[Image:Km1776_side.jpg|right|thumb|200px|A KM177-6 from the front side]]
[[Image:Km1776_torque.jpg|right|thumb|200px|A KM177-6 torque convertor]]
The '''KM177-6''' (also known as F4A23)is a four-speed electronic automatic transaxle built by Mitsubishi and was used in all [[TP]] models and carburettored [[:Category:Second Generation|Second Generation]] models.

After discovering that the [[KM175]] was failing often in service, [[MMAL]] decided that both carby and fuel-injected TP Magnas would be fitted with the stronger transaxle.

The KM177-6 was very similar to the [[KM177]] which was introduced in the fuel-injected [[TN]]. As with the KM177 and KM175 before it, it uses a damper clutch in the torque converter which causes the converter to lock at low vehicle speeds. The operation of the clutch is controlled by the Transaxle Control Unit.

As with the KM175 and KM177, gear selection is electronic and is controlled by solenoids activated by the Transaxle Control Unit. The TCU uses information from sensors which provide information on vehicle speed, throttle position, engine coolant temperature, gear lever position, engine speed, transfer shaft speed, overdrive switch and kickdown drum speed.

Differences between the KM177 and KM177-6 include a revised final drive ratio and the introduction of power and economy modes (which required a different transaxle control unit).

Power and economy mode was a change made to the transaxle control unit and changed when the transmission kicked down and upchanged. In power mode, upchanges occured at higher rpm, while the throttle was more sensitive for downchanges.

==Technical data==
{|cellpadding="3" align="left"
|'''Lubricant'''
|Mitsubishi ELC-4 ATF, Castrol TQM-SP, Valvoline Type M-II Special
|-
|'''Capacity'''
|5.8 Litres
|-
|'''Torque Convertor Stall Speed'''
|2100 - 2500 rpm (TP), 1800 - 2800 rpm (TR/S Carby)
|-
|-colspan="2"
|'''GEAR RATIOS'''
|-
|'''Final Drive'''
|3.900
|-style="align: left"
|'''1st'''
|2.551
|-
|'''2nd'''
|1.488
|-
|'''3rd'''
|1.000
|-
|'''4th'''
|0.685
|-
|'''Reverse'''
|2.176
|}

[[Category: First Generation]]
[[Category: Automatic Transaxles]]

KM177-6 - Revision history

Cartman02au at 01:25, 11 January 2010

Administrator: Protected "KM177-6" [edit=sysop:move=sysop]